Honda Pioneer SXS500M 2019 Owner's Manual page 137

Changing Oil
Refer to Safety Precautions on page 91.
Change the oil with the rear final gear at normal operating
temperature to assure complete and rapid draining.
1. Park the Honda SXS on a firm, level surface.
2. Place an oil drain pan under the oil drain plug.
3. Remove the oil filler cap and the drain plug.
4. After the oil has completely drained (3 – 5 minutes), reinstall the drain
plug with a new sealing washer and tighten it to the specified torque:
9 lbf·ft (12 N·m, 1.2 kgf·m)
5. Fill the rear final gear with the recommended oil.
5.1 US oz (150 cm
6. Make sure the oil level is at the lower edge of the oil filler
inspection hole.
7. Apply a thin coat of grease to a new O-ring, and insert it into the
oil filler cap groove.
8. Install and tighten oil filler cap to the specified torque:
9 lbf·ft (12 N·m, 1.2 kgf·m)
9. Pour the drained oil into a suitable container and dispose of it in
an approved manner (page 188).
NOTICE
Improper disposal of drained fluids is harmful to the environment.
RIGHT REAR
O-ring
oil drain plug
Rear Final Gear Oil
)
3
sealing washer
lower edge of
oil filler
inspection hole
oil filler cap
Servicing Your Honda
127