Advertisement
TROUBLESHOOTING
Problem
Possible Cause
When remote
control switch
is activated, a
clicking sound
Battery is inadequate
occurs and
or defective.
winch does
not operate in
either the power
in or power
out mode.
Battery is not fully
charged.
Faulty battery cable
or connections.
Poor electrical
grounding of thermo
relay wire.
Worn or damaged
motor brushes.
Vehicle not running.
Winch Lacks
Power, pulls
Ground and power
slower than
cables are loosely
normal, stalls
connected to battery
or does not run
or winch terminals.
at all.
Battery is not fully
charged.
Battery is inadequate
or defective.
Battery terminals are
corroded.
Vehicle not running.
Possible Solution
Replace battery with 650 cold cranking amp
rating or greater.
Charge the battery.
Clean and tighten all battery connections.
Be sure connections are clean and tight.
Replace winch motor.
Start vehicle & keep running during winching.
Be sure connections are clean and tight.
Charge the battery.
Replace battery with 650 cold cranking amp
rating or greater.
Clean battery terminals.
Start vehicle & keep running during winching.
13
Advertisement
