Download Print this page

Quadratec Q-Performance Stealth Series Quick Start Manual page 14

Winch with integrated solenoid & synthetic winch line
Hide thumbs Also See for Q-Performance Stealth Series:

Advertisement

TROUBLESHOOTING
Problem
Possible Cause
When winch
control is
activated, the
Remote control is
winch operates
damaged.
only in one
direction.
Ground and power
cables are loosely
connected to battery
or winch terminals.
Battery is not fully
charged.
Battery is inadequate
or defective.
Battery terminals are
corroded.
Solenoids inside the
control pack is stuck
or damaged.
Vehicle not running.
Winch does
Winch line is spooled
not hold
onto winch drum in
a load.
the wrong direction.
Load exceeds winch
rating.
Brake inside the
winch drum is badly
worn or broken.
Possible Solution
Check remote control and its cable. Check all
connections and replace if necessary.
Be sure connections are clean and tight.
Charge the battery.
Replace battery with 650 cold cranking amp
rating or greater.
Clean battery terminals.
Replace Solenoid Module.
Start vehicle & keep running during winching.
Winch line must exit from the bottom of the
drum. Re-Spool in the proper direction.
Do Not exceed the line pull rating shown in the
ID label on the winch motor. Refer to the winch
operators manual for correct rating.
Replace entire drum and brake assembly.
14

Advertisement

loading
Need help?

Need help?

Do you have a question about the Q-Performance Stealth Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

10 stealth12 stealth92122.403192122.4041