Quadratec Q-Performance Stealth Series Quick Start Manual page 5

Assembly and Installation (Continued)
Winch Line
Cotter Pin
neutral gear) with the winch up a slight
flat incline. See your glovebox sized
"Self-Recovery Winch Operator's Guide"
to properly set up this pull with full
understanding of all safety precautions.
To fully stretch the winch line, you will
need about 500 lbs. of tension on the
cable during the operation. Once you
have completed the pull, be sure to
rewind cable in tight rows not allowing
upper rows to intertwine with lower
Learn to Winch Properly
Your winch should add greater utility and
enjoyment to your off-road adventures.
Keep in mind, however, the weight of
your vehicle and the forces required to
move it create certain hazards. Self
recovery that is safe for you, bystanders
and the environment requires product
knowledge, planning and practice.
Be aware there are specific techniques
and hazards associated with recovery
winching. Begin by understanding ALL
Safety Information found in this winch
installation manual and then supplement
Winch Hook
rows. Review Operator's Guide for this
extremely important procedure.
Attach the Winch Hook to Synthetic
Winch Line:
Attach as shown using the included
cotter pin through the clevis pin. Spread
the cotter pin ends to secure the hook. Be
sure to keep the safety latch clean and
lubricated at all times.
CAREFULLY STUDY WINCH USER GUIDE SUPPLIED WITH YOUR WINCH.
your knowledge by studying the
supplied glovebox-sized Q Series Winch
Operator's Guide Manual and also by
learning from more experienced off-road
enthusiasts. The broad conditions where
winch-based self-recovery are required
are discussed in the supplied glovebox
sized guidebook. Keep the supplied
booklet in the winch installed vehicle
glovebox after winch installation as a
handy reference. Develop and rely on
your own good judgment at all times.
5