Advertisement
TROUBLESHOOTING
Problem
Possible Cause
When remote
control switch is
activated, a click-
ing sound occurs
Battery is inadequate
and winch does
or defective.
not operate in
either the power
in or power
out mode.
Battery is not fully
charged
Faulty battery cable
or connections
Poor electrical
grounding of thermo
relay wire
Worn or damaged
motor brushes
Vehicle not running
Winch Lacks
Ground and power
Power, pulls
cables are loosely
slower than
connected to battery
normal, stalls or
or winch terminals
does not run at all.
Battery is not fully
charged
Battery is inadequate
or defective.
Battery terminals are
corroded.
Vehicle not running
Replace battery with 650 cold cranking amp
rating or greater.
Charge the battery.
Clean and tighten all battery connections.
Be sure connections are clean and tight.
Replace winch motor.
Start vehicle & keep running during winching
Be sure connections are clean and tight.
Charge the battery.
Replace battery with 650 cold cranking amp
rating or greater.
Clean battery terminals.
Start vehicle & keep running during winching
The Trusted Source
13
Possible Solution
Advertisement
