Advertisement
Assembly and Installation
Positive Cable Red Tip
(To Positive Battery Terminal)
Electric Cable Connection Attach
the black (negative) ground cable to
motor terminal and black solenoid
ground wire with brass bolt. Tighten the
brass bolt onto terminal using a 13mm
wrench. Then attach positive and
negative cables to their corresponding
battery terminals.
DO NOT OVER TIGHTEN.
FIRE/ELECTRICAL SPARK/CHEMICAL BURN HAZARDS:
CONNECTING WINCH TO BATTERY AND WINCH OPERATION MAY CAUSE
ELECTRICAL ARCS. NEVER INSTALL OR USE WINCH WHERE GASOLINE
LEAKS, VAPORS OR OTHER FLAMMABLES ARE PRESENT.
ALWAYS WEAR EYE PROTECTION & REMOVE JEWELRY WHEN
WORKING WITH BATTERY OR INSTALLING WINCH ELECTRICAL CABLES.
PLAN CONNECTIONS TO AVOID FUEL LINES, HOT OR ROTATING PARTS.
NEVER ROUTE ELECTRICAL CABLE OR WINCH CONTROLLER ACROSS
SHARP EDGES, DOORS OR OTHER PINCH POINTS.
ALWAYS USE SUPPLIED TERMINAL BOOTS, INSULATE ANY OTHER
EXPOSED CONNECTIONS AND NEATLY SUPPORT ALL WIRING.
DEPENDING ON YOUR LEVEL OF KNOWLEDGE REGARDING ELECTRICAL
WIRING, YOU MAY WISH TO HAVE THIS PROCEDURE PERFORMED BY A
QUALIFIED TECHNICIAN.
3
Motor Stator
Cable Yellow
Motor Rotator
Cable Red
Motor Stator
Cable Green
Solenoid Ground
Wire (See below)
Negative Ground Cable
Black Tip (To Negative
Terminal on Battery)
Motor &
Solenoid
Ground Wires
Advertisement
