Technical Specifications; Specifications 100/30 And 100/50 - Victron energy SmartSolar MPPT 100/30 Manual

10. Technical specifications

10.1. Specifications 100/30 and 100/50

Battery voltage (auto select)
Rated charge current
1a,b
Nominal PV power, 12V
1a,b
Nominal PV power, 24V
Maximum PV open circuit voltage
2
Max. PV short circuit current
Maximum efficiency
Self-consumption
Charge algorithm
Charge voltage 'absorption'
Charge voltage 'float'
Charge voltage 'equalization'
Temperature compensation
Protection
Operating temperature
Humidity
Maximum altitude
Environmental condition
Pollution degree
Data communication
ENCLOSURE
Colour
Power terminals
Protection category
Weight
Dimensions h x w x d
STANDARDS
Safety
1a) The solar charger will limit input power if more PV power is connected.
1b) The PV voltage must exceed Vbat + 5V for the controller to start. Thereafter the minimum PV voltage is Vbat + 1V.
2) A higher short circuit current may damage the solar charger in case of reverse polarity connection of the PV array.
3) Equalization is by default disabled.
4) For more information on data communication see the
our website.
Page 53
MPPT solar charger manual
Multi-stage adaptive (eight pre-programmed algorithms) or user defined
3
data communication paper
MPPT 100/30
12V or 24V
30A
440W
880W
100V
30A
98%
12V: 30mA / 24V: 20mA
algorithm
14.4V / 28.8V (adjustable)
13.8V / 27.6V (adjustable)
16.2V / 28.8V (adjustable)
12V: -16mV/°C / 24V: -32mV/°C
Output short circuit, over temperature
-30°C to +60°C (full rated output up to 40°C)
95%, non-condensing
5000m (full rated output up to 2000m)
Indoor type 1, unconditioned
PD3
VE.Direct port
Bluetooth, via the VictronConnect app
Blue (RAL 5012)
16 mm² / AWG6
IP43 (electronic components), IP22 (connection area)
1.3 kg
130 x 186 x 70 mm
EN/IEC 62109-1, UL 1741, CSA C22.2
in the Technical information section
MPPT 100/50
50A
700W
1400W
100V
50A
4
on
Technical specifications