Configuration And Settings; How To Change Settings; Settings Via The Victronconnect App; Settings Via The Jumper Link - Victron energy BlueSolar MPPT 75/10 Manual

5. Configuration and settings

The solar charger settings can be configured so it can be taylored specifically for the system it is used in.
Do not change solar charger settings unless you know what they are and what the effect of changing these
settings is going to be.
Incorrect settings may cause system problems including damage to batteries. When in doubt, seek advice
from an experienced Victron Energy installer, dealer or distributor.

5.1. How to change settings

There are several methods that can be used to change these settings. Some of these allow all settings to be configured, but
others might have limitations:
• The VictronConnect App - All settings can be changed and the firmware can be updated.
• The jumper link in the VE.Direct port - The Load output algorithm can be selected.
• The MPPT Control display (optional) - Most settings can be changed.
Do not change solar charger settings unless you know what they are and what the effect of changing these
settings can be. Incorrect settings may cause system problems including damage to batteries. When in doubt,
seek advice from an experienced Victron Energy installer, dealer or distributor.

5.1.1. Settings via the VictronConnect App

The VictronConnect App can be used to change all solar charger settings and can be used to update the firmware.
This manual only covers the VictronConnect solar charger specific items. For more general information on the VictronConnect
App, like how use it or how to connect see the
To access the solar charger settings, navigate to the settings page. Do this by clicking on the cog icon
home screen.
The settings page provides access to view and/or to change the solar charger settings.
For information about each setting and how to update firmware see the

5.1.2. Settings via the jumper link

If the load output algorithm is configured via VictronConnect or the MPPT Control display the jumper link is not
used and it needs to be removed. Configuration via the jumper link is only needed in case the load output
algorithm cannot be configured by any other means.
Page 14
MPPT solar charger manual
VictronConnect manual.
All settings explained [15]
at the top right of the
chapter.
Configuration and settings