Chapter 1: Overview; Table 1-1: Acs100 Model Numbering System - Aerotech ACS100 Hardware Manual

ACS Hardware Manual

Chapter 1: Overview

N O T E : Aerotech continually improves its product offerings; listed options may be superseded at any
time. All drawings and illustrations are for reference only and were complete and accurate as of this
manual's release. Refer to www.aerotech.com for the most up-to-date information.
Table 1-1: ACS100 Model Numbering System
ACS Mechanical-Bearing Direct-Drive Rotary Collet Stage, 100 mm diameter
Stage Size (Required)
-85
-135
Chuck Style (Required)
-ER8
-ER8MB
Feedback (Required)
-E1
-E2
-E3
-E4
-E5
NOTE: Digital output encoder signals are synthesized with a 16 MHz clock. Ensure that the encoder sample rate on the controller is
at least 16 MHz or higher (slower clock rates are available on request).
Rear Seal (Optional)
-SL
Connector (Required)
-CN1
-CN2
Wrench (Optional)
-WR
Air Purge (Optional)
-PR
Metrology (Required)
-PL1
-PL2
Accessories (To be Ordered as a Separate Line Item)
Collet-ER8-CLTxx
Collet-ER8MB-CLTxx
CGF
www.aerotech.com
85 mm stage height; 0.6 N·m continuous torque
135 mm stage height; 1.6 N·m continuous torque
ER8 ultra-precision collet
ER8 microbore collet
Incremental encoder, 1 Vpp, sine wave output
Incremental encoder, Digital, RS422 line-driver, x5 interpolation
Incremental encoder, Digital, RS422 line-driver, x10 interpolation
Incremental encoder, Digital, RS422 line-driver, x25 interpolation
Incremental encoder, Digital, RS422 line-driver, x50 interpolation
Rear seal
4-pin high-powered D-style motor and 25-pin D-style feedback connectors
25-pin D-style motor and 25-pin D-style feedback connectors
Wrench for changing the collet
Aerotech P/N: MFB25378-01 [Qty-2]
Air purge fitting to positive pressurize ACS stage to limit ingress of airborne
particulates
Uncalibrated with performance plots
Calibrated (HALAR) with performance plots
ER8 DIN6499AA electropolished collet, 0.5 mm to 5 mm part sizes diameter
available
ER8 DIN6499AA electropolished mircro-bore collet, 0.2 mm to 0.9 mm part sizes
diameter available
Collet and gripper filtration kit
Chapter 1: Overview
9