Overmolded Diaphragm Repair - VERDER HI-CLEAN VA-2H25 Repair Parts List Manual

Overmolded Diaphragm Diaphragm Repair
Overmolded Overmolded Diaphragm
Tools Required Tools Tools Required Required
• Torque wrench
• 19 mm open end wrench
• O-ring pick
• Lithium base grease
NOTE: Center section gasket is dependent on
NOTE: NOTE:
diaphragm material. If changing diaphragm material,
it may be necessary to also replace the center
section air cover gaskets. See
for affected air cover gaskets.
Disassemble the the Overmolded Overmolded Diaphragms
Disassemble Disassemble the Overmolded
NOTE: Diaphragm kits are available in a range of
NOTE: NOTE:
materials and styles. See Parts section.
1. Follow the Pressure Relief Procedure, page 9
2. Remove the manifolds and disassemble
the check valves as explained in
Check Valve Repair, page
3. Remove the clamps (21) from the fluid covers
(15), then pull the fluid covers off of the pump.
4. Once the fluid covers are removed, the
diaphragm on the side of the pump which was
last pressurized with air will be separated from
the center section/air cover. This allows you to
grip the diaphragms.
812.0063
Repair
Repair
Diaphragms, page 23,
Diaphragms
Diaphragms
.
12.
5. To loosen, grip both diaphragms securely around
the outer edge and rotate counterclockwise. One
diaphragm assembly will come free and the other
will remain attached to the shaft. Remove the
freed diaphragm (10), screw (14) if it remains in
the shaft, and air side plate (9).
6. Pull the opposite diaphragm assembly and shaft
(24) out of the center housing (101). Hold the
shaft flats with a 19 mm open end wrench and
remove the diaphragm and air side plate from
the shaft.
7. Inspect the diaphragm shaft (24) for wear or
scratches. If it is damaged, inspect the bearings
(111) in place. If the bearings are damaged, refer
to Center Section Repair, page
8. Clean all parts and inspect for wear or damage.
Replace parts as needed.
Repair
18.
15