Summary of Contents for HAAS + SOHN HSP 6 Pelletto III 419.08
Page 1
Technische Dokumentation Geräteblatt Pelletto III 419.08, 434.08 Geräteblatt Pelletto III 419.08, 434.08 Geräteblatt Pelletofen Fiche technique Poêle à pellets Scheda tecnica Stufe pellet Equipment sheet Pellet stove Tehnički list Kotel na pelete Tehnični list Kotel na pelete 0541908101400d...
Page 2
Notes in the text Of utmost importance there are the notes entitled WARNING. The notes entitled WARNING advise you on serious danger of damage to the heating device or of an injury. The note entitled Notice advises you on possible damage to your heating device. The note entitled Important calls your attention to the information important for the operation of your heating device.
1. Technical data Pelletto III 419.08 Pelletto III 434.08 Heat output range: 2,4 – 8,3 kW 2,4 – 8,3 kW Nominal heat output: 8,0 kW 8,0 kW Height: 988 mm 1180 mm Width: 529/531 mm 531/533 mm Depth: 508 mm 498 mm Weight: 96/143/115 kg...
3. Cleaning work WARNING Before starting any cleaning work, the stove must be cool down! The mains plug must be pulled out of the power supply socket (always in advance)! Once the cleaning work is completed, the correct operating status of the device must be re- established: Put the combustion pot in correctly, close the combustion chamber door.
Page 9
WARNING If this is not done, the clinker will continue to accumulate. Then the device will no longer be able to ignite properly. Pellets can pile up in the combustion pot. In extreme cases, this can reach all the way back to the pellet chute.
4. Maintenance work WARNING Before starting any cleaning work, the stove must be cool down! The mains plug must be pulled out of the power supply socket (always in advance)! The frequency of maintenance in turn depends to a large extent on the pellet quality (ash content). Quality pellets have a low ash content of about 0.2-0.3%.
4.2. Cleaning the flue gas passes - long-time CAUTION After the consumption of 1000 kg of pellets at the latest, it is recommendable to check & clean the conduits of combustion products, the (induced) draught fan and the smoke flues. For cleaning, employ a brush or an ash exhauster.
Page 12
• Carry out the cleaning as pr the Fig. 3. Figure 3: Removing the side wall CAUTION After completion of the cleaning make sure that when putting back the covers, the seals are seated in the right positions. It is essential to replace defective seals.
Combustion chamber door/grey 1 piece 0541908006220 Seal glass 10x4 mm (900 mm) 1 piece 0040210040005 Door glass (383x224x4) 1 piece 0551908005305 Seal door 11 mm (1306 mm) 1 piece 0040300110006 5.3. Replacement parts list Pelletto III 419.08 Description Pos. Piece No.
Side wall left white 1 piece 0541908116165 Back wall 1 piece 0551908506118 5.4. Replacement parts list Pelletto III 419.08–C Description Pos. Piece No. PR Replacement parts list Pelletto III 419.08–C Side wall right anthracite 1 piece 0541908006140 Side part C ceramic ahorn right 1 piece 0541908016185 Front plate anthracite...
5.5. Replacement parts list Pelletto III 434.08 Description Pos. Piece No. PR Replacement parts list Pelletto III 434.08 Side wall right grey 1 piece 0543408006140 Side wall right white 1 piece 0543408116140 Front plate anthracite 1 piece 0543408006120 Side wall left grey 1 piece 0543408006150 Side wall left white...
5.6. Replacement parts list Pelletto III 434.08–C Description Pos. Piece No. PR Replacement parts list Pelletto III 434.08–C Side wall right anthracite 1 piece 0543408716140 Side part C ceramic ahorn right 1 piece 0543408716185 Side part C ceramic coffee-bean right 1 piece 0543208716185 Front plate anthracite...