Accessories; Installation Procedure - Kenwood KDC-6060R Instruction Manual

A ccessories
External view
1
2
3
4
2CA U TION
The use of any accessories except for those provided might result
in damage to the unit. M ake sure only to use the accessories
shipped w ith the unit, as show n above.
Inst allat ion Procedure
1. To prevent short circuits, remove the key from the ignition and
disconnect the - terminal of the battery.
2. M ake the proper input and output cable connections for each unit.
3. Connect the cable on the w iring harness.
4. Take Connector B on the w iring harness and connect it to the
speaker connector in your vehicle.
5. Take Connector A on the w iring harness and connect it to the
external pow er connector on your vehicle.
6. Connect the w iring harness connector to the unit.
7. Install the unit in your car.
8. Reconnect the - terminal of the battery.
9. Press the reset button.
Number of items
..........................................1
..........................................2
..........................................1
..........................................1
2CA U TION
• If your car is not prepared for this special connection-system,
consult your KENWOOD dealer.
• Only use antenna conversion adapters (ISO-JASO) w hen the
antenna cord has an ISO plug.
• M ake sure that all cable connections are securely made by
inserting jacks until they lock completely.
• If your vehicle' s ignition does not have an ACC position, or if
the ignition cable is connected to a pow er source w ith constant
voltage such as a battery cable, the pow er w ill not be linked
w ith the ignition (i.e., it w ill not turn on and off along w ith the
ignition). If you w ant to link the unit' s pow er w ith the ignition,
connect the ignition cable to a pow er source that can be turned
on and off w ith the ignition key.
• If the fuse blow s, first make sure that the cables have not
caused a short circuit, then replace the old fuse w ith one w ith
the same rating.
• Do not let unconnected cables or terminals touch metal on the
car or anything else conducting electricity. To prevent short
circuits, also do not remove the caps on the ends of the
unconnected cables or the terminals.
• Connect the speaker cables correctly to the terminals to w hich
they correspond. The unit may receive damage or fail to w ork if
you share the - cables and/or ground them to any metal part in
the car.
• After the unit is installed, check w hether the brake lamps,
indicators, w ipers, etc. on the car are w orking properly.
• Insulate unconnected cables w ith vinyl tape or other similar
material.
• Some disc changers need conversion cables for connection.
See the section on "Safety Precautions" for details.
• If the console has a lid, make sure to install the unit so that the
faceplate does not hit the lid w hen closing and opening.
• M ount the unit so that the mounting angle is 30° or less.
— 37 —