Assa Abloy Norton 6300 Series Installation And Instruction Manual page 7

6
Pull Side End Cap Installation
A. Install (2) 1/4-20 x 3/8" length cap
screws in center tapped holes on
each end of the Back Plate
leaving about 3/16" gap between
head of screw and back plate.
B. Slide appropriate end cap (shown
at right) behind the screw heads
from Step 5A and tighten screws.
NOTE: The end cap with the 3-
position switch is always located
on the conduit side of the Back
Plate.
C. Plug the 3-position switch
connector from the end cap into
the main board 123 HOLD OPEN
connector and fan connector from
fan to backplate board.
7
Pull Side Arm Installation
Illustration at right shows the operator
looking from the top down.
A. Use an adjustable wrench on the
top pinion square to rotate the
pinion 45 degrees toward the door
hinge, as shown. You will feel
resistance from the spring.
B. While holding the pinion as stated in
Step 6A, slide the arm on the
bottom pinion square oriented as
shown.
C. Use the 1/4-20 x 7/8" cap screw and
nut to secure the arm onto the
pinion square.
D. Open the door approximately 30°
and mate the slider in the track to
the tapped hole on the end of the
arm. Use the 3/16" hex wrench to
rotate the slider bolt counter
clockwise until the slide is tight in
the arm.
Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Endcap Assembly w/ fan
1/4-20 X 3/8"
Cap Screws
45 Degrees
1/4-20 X 7/8"
Cap Screw
Slide Arm On
& Nut
Page 7
Conduit Holes
Endcap Assembly w/ switch
Orient arm as shown
Standard Pull Side Arm Shown
Double Egress RH Arm Shown
Use Wrench Here (See Step 12A)
80-9363-0001-020 Rev 7 08/17