Wallbox PULSAR PLUS Installation Manual page 10

EN
Operating
AMPS
40
CONNECTED
18
Compatibility
This Wallbox charger can be used with any
Battery or Plug-In Hybrid Electric Vehicle (BEV/
PHEV) that is compliant with SAE J1772
(Including Teslas using the Tesla provided
adapter).
Charging
With your charger powered, connect the EV
connector to your vehicle's charge port/input.
Connecting your charger will automatically initiate
the charging process.
If you are using the myWallbox app and have
either locked your charger or set a charging
schedule, the charging process will not start
until you use myWallbox to unlock your charger
or until the scheduled charging time.
Troubleshooting
If the LED halo is red (error notification), it means
your charger has detected a safety issue with your
electrical connection or vehicle.
Note that some errors will initiate an automatic
reset after 15 seconds if the detected fault is
resolved.
If the error does not automatically reset, unplug
the EV connector from the vehicle and cycle
through a power off/power on sequence by
switching off the circuit at the circuit breaker
and then switching it back on.
If the error persists, contact Wallbox customer
service for additional instructions on how to
resolve the error.
Service
Need more assistance? Contact Wallbox customer service:
(888) 787-5780
support.wallbox.com/na
service.na@wallbox.com
www.wallbox.com
EN
19