Kenwood HM52 Series Instructions Manual page 3

Always unplug the appliance when not in
l
use, before fitting or removing parts or before
cleaning.
Appliances can be used by persons with
l
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use
of the appliance in a safe way and if they
understand the hazards involved.
Children should be supervised to ensure that
l
they do not play with the appliance.
This appliance shall not be used by children.
l
Keep the appliance and its cord out of reach
of children.
Only use the appliance for its intended
l
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
rear of your handmixer.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using your handmixer
for the first time
Wash the parts (see 'cleaning').
l
key
a speed switch
HM520 - 3 speed
HM530 - 5 speed
b tool release button
c beaters
d kneader with collar (if supplied)
e kneader without collar (if supplied)
f tool storage
g cord tidy
to use your handmixer
1 Unwrap the cord and make sure
the speed switch a is in the off "O"
position. Ensure the tool storage f
has been removed.
2 Insert the beaters or kneaders 1 –
turn and push until a positive click is
felt.
Important: The kneader with the
collar d will only fit into the larger
socket.
3 Plug in.
4 With the ingredients in a bowl of an
appropriate size, place the beaters/
kneaders into the bowl.
5 Pull the speed switch backwards
to reach the desired speed (the first
dot on the handmixer body is the
slowest speed setting). Line up the
dot on the side of the speed switch
with the corresponding speed.
3