Using The Extractor Hood As An Exhaust Air Hood; Converting The Extractor Hood To A Circulation Hood; Electrical Connection - KKT KOLBE PROFI FREE Series User Manual

Installation
!
Only connect the appliance to the power
supply once it is properly installed.
7.2 Using the extractor hood as
an exhaust air hood (with air
extracted to outdoors)
If the extractor hood has been fitted at
the factory with a carbon filter, this must
be removed. It is only practicable to use
this when operating your hood in circula-
tion mode.
7.3 Converting the extractor
hood to a circulation hood
If you wish to use an appropriately fitted
hood as a circulation hood, you must
mount the active carbon filter(s) to the
fan motor before using the hood. The ac-
tive carbon filter(s) is/are included in the
scope of supply with some
Othe rwise you must obtain the active
carbon filter(s) from the supplier of your
e xtractor hood. You must also change
your hood over to the „Filter position" at
the de vice provide d (le ve r or ball hand-
le).

7.4 Electrical connection

Be fore conne cting the e xtractor hood,
che ck that the voltage state d on the ra-
ting plate (V) agrees with the supply vol-
tage in your home.
Ne ve r install the appliance if the data
on the rating plate does not agree with
your supply voltage.
You will find the rating plate inside the
appliance, behind the grease filter.
If the extractor hood is fitted with a
standard conne ctor plug, conne ct this
to an easily accessible standard socket.
If the appliance is not fitted with a con-
ne ctor plug, a two-pole switch, confor-
ming to standards with a minimum open
contact gap of 3 mm is to be installed by
an authorized tradesman in an easily ac-
mode ls.
cessible location.
7.5 Mounting the carbon lter
You will find the mounting instructions
for the carbon filter in its packaging. To
mount the carbon filter, remove the gre-
ase filter(s), fit the carbon filter according
to its mounting instructions and refit the
grease filter(s).
33