KKT KOLBE INTEGRA 606 User Manual page 39

The range hood must be pushed up until the mountings "click" over the construction the
The range hood must be pushed up until the mountings "click" over the construction the
range hood is to be mounted in.
range hood is to be mounted in.
If the mountings does not "click" they can be pushed in place, b y pressing on the screws
If the mountings does not "click" they can be pushed in place, b y pressing on the screws
that holds the mountings. This is done by pushing through the four holes in the co rners of
that holds the mountings. This is done by pushing through the four holes in the co rners of
Mounting the hood
the range hood with a screwdriver.
the range hood with a screwdriver.
Note: when mounting in a horizontal division recommends that the range hood
Note: when mounting in a horizontal division recommends that the range hood
is insulated to avoid noise nuisance.
is insulated to avoid noise nuisance.
4
4
Adjust the mountings until the edge of the
Adjust the mountings until the edge of the
range hood is level to the ceiling. This is
range hood is level to the ceiling. This is
done using a Philips screwdriver through the
done using a Philips screwdriver through the
four holes in the corners of the range hood.
four holes in the corners of the range hood.
Adjust the brackets until so that the edge
of the cooker hood is level to the ceiling.
This is done by inserting a screwdriver
6
6
trough the four holes in the corner of the
range hood.
The vent pipe must be mounted after the adjustment of the range hood. Thermex
The vent pipe must be mounted after the adjustment of the range hood. Thermex
recommends that a back v alve is mounted on the vent installation to prevent draft
recommends that a back v alve is mounted on the vent installation to prevent draft
through the vent. When installing an external motor from Thermex the none-return valve
through the vent. When installing an external motor from Thermex the none-return valve
is placed by the motor.
is placed by the motor.
Note: When installing a non-return valve, make sure that the valve can open freely.
If the valve cannot be opened freely, the suction power may be reduced and the opera-
ting noise of the cooker hood may increase.
Note: If the extractor hood is used for for recirculating air without venting to the outside,
it is important that the air outlet is not blocked, as otherwise the extractor hood will be
damaged, the capacity can be reduced and the operating noise will increase. It should
also be noted that a non-return valve cannot be installed.
4x
4x
5
5
NOTE: After the adjustment the enclosed
NOTE: After the adjustment the enclosed
plugs must be mounted in the screw
plugs must be mounted in the screw
holes. Otherwise noise nuisance can be holes. Otherwise noise nuisance can be
experienced.
experienced.
Note: After adjustment, the enclosed
plugs must be mounted in the screw
holes.
Otherwise, annoying noises may occur.
39