Installation Of The Camera - HIKVISION HOT Series User Manual

If the product does not function properly, contact

your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.

2.1 Installation of the Camera

Before you start:
The installation of type I and type II camera are similar.
Following pictures are only for reference. Take the
actual object as standard.
2.1.1 Ceiling/Wall Mounting without Junction Box
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1. Drill the screw holes and the cable hole (optional)
on the ceiling.
2. Route the cables through the cable hole, or the side
opening.
3. Attach the bracket to the ceiling, and secure the
camera with supplied screws. For cement ceiling,
you need to install the expansion bolts at first.
Figure 2-1 Attach the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
4. Connect the corresponding power cord, and video
cable.
5. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, loosen the screws and the trim ring to adjust
the position.
Rotation Position
1). Loosen the T adjusting screw to adjust the tilt
position [0° to 180°].
2). Loosen the trim ring to adjust the pan position
[0° to 360°].
3). Loosen the R adjusting screw to adjust the
rotation position [0° to 360°].
6. Tighten screws and the trim ring to finish the
installation.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole on the ceiling
according to the drill template.
Figure 2-2 3-Axis Adjustment
[0° to 360°]
Tilt Position [0° to 180°]
T
R