Toro Groundsmaster 4500-D Operator's Manual page 17

Note:
If you have the switch in the H/L AUTO
position, you cannot lower the decks from the
fully-raised position unless the traction pedal is in
neutral and the machine is stopped.
Cruise-Control Switch
The cruise-control switch locks in the cruise control
to maintain the desired ground speed
Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the
cruise-control function, and the front of the switch sets
the desired ground speed.
Once the cruise control is set, you can change the
speed using the InfoCenter
1. Power point
Lift Switches
The lift switches raise and lower the cutting units
(Figure 11). Press the switches forward to lower the
cutting units and rearward to raise the cutting units.
When starting the machine, with the cutting units in
the down position, press the lift switch down to allow
the cutting units to float and mow.
Note:
The cutting units do not lower while in the
high-speed range and they do not raise or lower if you
are out of the seat. Also, the cutting units lower with
the key in the O position and you are in the seat.
N
Light Switch
Press the light switch upward to turn the lights to the
O position (Figure 11).
N
Press the light switch downward to turn the lights to
the O position.
FF
Power Point
Use the power point (Figure
12 V electrical accessories.
(Figure
(Figure 30).
Figure 12
2. Cruise-control switch
13) to power optional
12).
1. Power point
Bag Holder
Use the bag holder for storage
Seat Adjustments
g028454
Seat-Adjustment Lever
Move the seat adjustment lever on the side of the
seat outward, slide the seat to the desired position,
and release the lever to lock the seat into position
(Figure 14).
1. Weight gauge
2. Weight adjustment lever
3. Seat adjustment lever
17
Figure 13
2. Bag holder
(Figure 13).
Figure 14
4. Seat-back adjustment
lever
5. Armrest adjustment knob
g036845
g024916