Toro Groundsmaster 4500-D Operator's Manual page 48

•
Steering-cylinder ball joints (2) as shown in
45
1. Top fitting on kingpin
•
Tie-rod ball joints (2) as shown in
•
Kingpin bushings (2) as shown in
Important:
Lubricate the top fitting on the
kingpin no more than annually (2 pumps).
•
Lift-arm bushings (1 per cutting unit) as shown in
Figure 46
•
Lift-cylinder bushings (2 per cutting unit) as shown
in Figure 46
Figure 45
Figure 45
Figure 45
Figure 46
•
Figure Cutting-unit spindle-shaft bearings (2 per cutting
unit) as shown in
Note:
You can use either fitting, whichever is
more accessible. Pump grease into the fitting
until a small amount appears at the bottom of the
spindle housing (under the cutting unit).
g009706
•
Cutting-unit carrier-arm bushings (1 per cutting
unit) as shown in
•
Rear roller bearings (2 per cutting unit) as shown
in Figure 48
Important:
in each roller mount aligns with the grease
hole in each end of the roller shaft. To help
align the groove and the hole, there is also an
alignment mark on 1 end of the roller shaft.
g009707
48
Figure 47
Figure 47
Figure 47
Figure 48
Make sure that the grease groove
g009708
g005979