32 | FIRMWARE UPDATE | GEOKON
For all other Nodes/Supervisors:
a.
Connect the B8800-5 (update cable) to the "232" connector on the
bottom circuit board. Refer to the figure below.
FIGURE 28: RS-232 Connector Detail
b.
Connect the B8800-5 update cable to the 8001-7 cable (USB to RS-232
adapter).
c.
Connect the 8001-7 cable to the computer. The figure below shows the
completed connection.
B8800-5
Update Cable
8001-7
USB to RS-232 Adapter
FIGURE 29: Update Cable Detail
5.
Move all channel select dipswitches to the "On" position. Refer to the figure
below.
FIGURE 30: Channel Selector Switch
28:
29:
30: