3
WORK
3.1
Removing the seat
3.2
Mounting the seat
–
Hook slot
of the seat onto screw
–
Push locking pin
into lock housing
click.
–
Finally, check that the seat is correctly mounted.
3.3
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
–
Pull on strap
–
Pull back the seat and lift it off.
101977-10
, press the rear downward and at the same time push it forward.
and push the back of the seat down until the locking pin locks in place with an audible
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Remove battery cover
–
Pull the EFI control unit
B01974-10
and raise the rear of the seat at the same time.
101988-10
p. 6)
.
off of the holder and set it to one side.
6