2
SETUP
–
Mount and tighten the rear mirror adapter and rear mirror on both sides.
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
–
Mount and tighten screw M8 of the right hand guard.
600646-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Pliers for footrest spring (58429083000)
–
Remove the protective plastic.
–
Carefully loosen and remove the tensioning belt over the link fork.
Info
An assistant prevents the motorcycle from falling over.
100308-01
–
Carefully loosen and remove the tensioning belts around the lower triple clamp.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the pallet.
–
Recharge the battery. (
–
Install the battery. (
–
Plug in connector
201925-10
–
Remove the rear fairing. (
–
Four markings
drill holes to the specified diameter in three stages.
Guideline
Hole diameter for grab handles
100312-10
–
Remove screws
–
Fit the rear fairing. (
100313-10
–
Mount the reflector.
Operation as a 2-seater
–
Fit the rear footrest bracket. (
201901-10
p. 7)
p. 8)
.
p. 9)
are found on the underside of the rear fairing. At these location,
.
p. 10)
p. 10)
14.50 mm (0.5709 in)
4