3
WORK
3.5
Installing the battery
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove lid
Charge the battery with a maximum of 10% of the capacity specified on the
battery housing
–
Switch off and disconnect the charger after charging.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
100151-10
Finishing work
–
Install the battery. (
–
Mount the seat. (
–
Set the clock. (
Main work
–
Insert the battery into the battery compartment with the terminals facing rearward.
Battery (YTZ10S)
–
Position retaining bracket
Guideline
Remaining screws, chassis
–
Position the positive cable and mount and tighten the screw.
B01975-11
Guideline
Remaining screws, chassis
–
Position positive terminal cover
–
Position negative cable
Guideline
Remaining screws, chassis
–
Position EFI control unit
–
Mount battery cover
B01976-10
Finishing work
–
Mount the seat. (
–
Set the clock. (
.
.
3 months
p. 8)
p. 6)
p. 12)
and mount and tighten screws
M6
M6
.
and mount and tighten the screw.
M6
.
.
p. 6)
p. 12)
8
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)