Rangemaster Professional+ 110 Gas User Manual & Installation & Service Instructions page 27

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
22. To Change an Oven Door Seal
Open the oven door. The seal is held in place by small hooks
on the rear face. At the corner, pull the seal diagonally away
from the door centre until that hook is released. Proceed to
the next hook and release it in a similar way, and so on. Use
force if the hooks are stiff, as the old seal will be discarded.
When fitting the new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door, and
proceed round the door, snapping in each hook in turn.
23. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to alter
the angle of the door. Loosen the bottom hinge fixing screws
and use the notch and a flat bladed screwdriver to move the
position of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
25