Rangemaster Professional+ 110 Gas User Manual & Installation & Service Instructions page 23

Check the appliance is electrically safe and gas sound when you have finished.
Hotplate Check
Check each burner in turn. Push in tap and turn to the large
flame symbol. Press ignition switch on fascia panel.
Grill Check
Check the grill operation.
Operation
Press the igniter button, and then press and hold the
grill control knob to the large flame symbol () for about
10 seconds.
If, when you release the control knob the burner goes out, the
safety device has not held in. Turn the grill control knob to '0'
and wait for one minute. Repeat the operation but hold the
button and control knob in for slightly longer.
Oven check
Set the clock to the time of day
When the clock is first connected the display will flash ( 0.00)

and ( ) alternately.
To set the clock to read the time of day turn and hold the
Timer knob to the clock symbol (
turn the Adjusting knob left or right until the clock shows the
time of day. Remember this is a 24 hour clock. Let go of the
Timer knob and it will spring back to the vertical oven manual
setting.
Turn on the oven and check that the oven fan starts to turn
and that the oven starts to heat up. Turn off the oven.
INSTALLATION
) and at the same time

Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws.
Customer care
Please complete your details in this Guide, inform the user
how to operate the cooker and hand over the Instructions.
Thank you.
21