Troubleshooting - Rangemaster Professional+ 110 Gas User Manual & Installation & Service Instructions

For safety's sake, push the side rails back into the grill
chamber.
If you need to remove the side rails to facilitate the cleaning
of the grill chamber, you can unhook them from the grill
chamber sides and wipe the sides clean with a soft cloth and
mild detergent.
ArtNo.331-0005 Removing the grill rail
Do not use any abrasive substances. DO NOT put the side
runners in a dishwasher.
Once you have finished, hook the side rails back onto the
sides of the chamber. To refit the frame, pull the side rails
forward and, for each side in turn, support the side rail and
press the frame down into the side rails. Replace the grill pan.
When refitting the grill pan, ensure that the wide rim is at the
front:
ArtNo.331-0006 Grill pan plan
Control Panel and Doors
Avoid using any abrasive cleaners, including cream cleaners,
on brushed Stainless Steel surfaces. For best results, use a
liquid detergent.
The control panel and knobs, and doors, should only be
cleaned with a soft cloth wrung out in clean hot soapy water.
After cleaning, polish with a dry cloth.
The Griddle
If the griddle is washed in a dishwasher then some
dishwasher residue may appear on the back. This is normal
and will not affect the performance of your griddle.
Ovens
The ovens have removable panels that have been coated with
a special enamel that partly cleans itself. This does not stop
all marks on the lining, but helps to reduce the amount of
manual cleaning needed.
The Cook & Clean panels work better above Gas Mark 6. If you
do most of your cooking below this temperature, occasionally
remove the panels and wipe with a lint free cloth and hot
soapy water. The panels should then be dried and replaced
and the oven heated at Gas Mark 6 for about one hour. This
will ensure the Cook & Clean panels are working effectively.
DO NOT use steel wool, oven cleaning pads, or any

other materials that will scratch the surface.
Removing the Oven Linings
Some of the lining panels can be removed for cleaning. You
will need to remove the shelves before removing the panels.
Each side of the oven is fixed with four fixing screws. You
don't have to remove the screws to remove the oven linings.
Simply lift each side panel upwards and they will slide off the
screws. Then pull them forwards:
Once the linings are removed, the oven enamel interior can
be cleaned.

Troubleshooting

Grill not cooking properly.
Are you using the pan and trivet supplied with the
cooker? Is the pan being used on the runners, not the
floor of the compartment? Is the grill tray pushed fully
back to stop?
The knobs get hot when I use the oven or the grill. Can I
avoid this?
Yes, this is caused by heat rising from the oven or the
grill, and heating them up. Don't leave the oven door
open. Make sure that the grill pan is pushed right back
to the 'back stop' when grilling. Always grill with the grill
compartment door open.
If there is an installation problem and I don't get my
original installer to come back to fix it, who pays?
You do. Service organisations will charge for their call-
outs if they are correcting work carried out by your
original installer. Therefore, it's in your own interest to
14