Power Button With Fingerprint Reader; Removing The Power Button With Fingerprint Reader - Dell G3 3500 Service Manual

10. Install the memory module.
11. Install the base cover.
12. Follow the procedure in

Power button with fingerprint reader

Removing the power button with fingerprint reader

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the memory module.
4. Remove the WLAN card.
5. Remove the solid-state drive in M.2 slot
6. Remove the solid-state drive in M.2 slot
7. Remove the battery.
8. Remove the coin-cell battery.
9. Remove the left fan.
10. Remove the right fan.
11. Remove the heat sink.
12. Remove the power-adapter
13. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
Steps
1. Locate the power button with fingerprint reader on your computer.
2. Remove the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.
3. Lift the power button with fingerprint-reader, along with the fingerprint-reader cable, off the palm-rest and keyboard assembly.
After working inside your computer.
Before working inside your
one.
two.
port.
computer.
Removing and installing components 51