Steps
1. Connect the battery cable to the system board, if applicable.
2. Place the base cover on top of the palm-rest and keyboard assembly.
3. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover
into place.
4. Tighten the four captive screws that secure the base cover to the palm-rest and keyboard assembly.
5. Replace the six (M2x7) screws that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in
Memory module
Removing the memory modules
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image indicates the location of the memory modules and provides a visual representation of the removal procedure.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
15