Installing the power button with fingerprint reader
Prerequisites
If your are replacing a component, remove the existing component before performing the installation procedure.
Steps
1. Locate the power button with fingerprint reader slot on your computer.
2. Align and place the power button with fingerprint reader on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.
Next steps
1. Install the
system
board.
2. Install the
power-adapter
3. Install the
heat
sink.
4. Install the
left
fan.
5. Install the
right
fan.
6. Install the
coin-cell
battery.
7. Install the battery.
8. Install the
solid-state drive in M.2 slot
9. Install the
solid-state drive in M.2 slot
10. Install the
WLAN
card.
11. Install the
memory
module.
12. Install the
base
cover.
13. Follow the procedure in
52
Removing and installing components
port.
two.
one.
After working inside your
computer.