Bosch WAT Series Instruction Manual And Installation Instructions page 45

Faults
Repeated, intensive foam-
ing.
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
Washing results not satis-
factory.
Noises in the detergent
drawer after switching on
the appliance.
Noises in the detergent
drawer while the i-DOS dos-
age is running.
The drum briefly jerks or
judders after the pro-
gramme has started.
The water is not being
pumped out.
Water is not visible in the
drum.
Spin results not satisfac-
tory.
Laundry wet/too damp.
Drum starts rotating briefly
several times.
The programme is taking
longer than usual.
The duration of the pro-
gramme changes during
the wash cycle.
Cause/remedy
Automatic dosing: i-DOS Check the dosage settings and, if required, reduce the
■
basic dosage.
~
If required, use a different liquid detergent/fabric softener.
Manual dosing: Have you used too much detergent? Add less detergent the
■
next time you run a wash cycle with the same load.
There is too much detergent/fabric softener in the dispensers. Do not fill the dis-
pensers above the max. mark.
i-DOS Check the dosage settings and, if required, increase the basic dosage.
■
"i-DOS Setting the dosage" on page 34
~
Use a different liquid detergent.
■
Ensure that the detergent/softener has not congealed or formed lumps. If
■
required, clean the detergent drawer and pump unit.
Not a fault – a function test of the i-DOS pump unit is being carried out.
Not a fault – the i-DOS pump is dosing detergent or fabric softener.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
Is $ selected (Rinse Hold = no final spin)?
■
Clean the drain pump.
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Is Easy-Iron selected?
■
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is eliminating an imbalance.
Not a fault – the unbalanced load detection system is eliminating an imbalance
■
by repeatedly redistributing the laundry.
Not a fault – the foam detection system is active; this adds an additional rinse
■
cycle.
Not a fault – the programme sequence is optimised for the specific washing pro-
cess. This may change the programme duration shown on the display panel.
Faults and what to do about them.
"i-DOS Setting the dosage" on page 34
Page 40
~
Page 27
~
Page 36
~
Page 31
~
en
45