Technical data
en
Faults
Odours in the washing
machine.
Loud noises, vibrations and
machine "wandering" dur-
ing the spin cycle.
The touch display does not
work while the appliance is
running.
There is detergent residue
on the laundry.
When the appliance is
paused, A flashes and
è lights up continuously.
When the appliance is
paused, A flashes and
è is off.
If you cannot rectify a fault yourself (after switching the machine off and then on again) or a repair is required:
Switch off the appliance and pull the mains plug out of the socket.
■
Turn off the tap and call the after-sales service.
■
J
Technical data
D imensions:
T e c h n i c a l d a t a
850 x 600 x 590 mm
(height x width x depth)
Weight:
70 - 85 kg (depending on model)
Mains connection:
Mains voltage 220 - 240 V, 50 Hz
Nominal current 10 A
Nominal power 1900 – 2300 W
Water pressure:
100 - 1000 kPa (1 - 10 bar)
Power consumption when switched
off:
0.10 W
46
Cause/remedy
Run the Drum Clean or Cotton 90 °C programme without laundry.
Add all-purpose washing powder or a detergent that contains a bleaching agent.
Note:
To prevent foaming, only use half the amount of detergent recommended by
the detergent manufacturer. Do not use detergents designed for woollens or deli-
cates.
Is the appliance level? Make the appliance level.
■
Are the appliance's feet secured? Secure the appliance's feet.
■
Have the transit bolts been removed? Remove the transit bolts.
■
Has there been a power failure?
■
Have the fuses blown/has the circuit breaker tripped? Switch on/replace the
■
fuses.
If the fault occurs repeatedly, call the after-sales service.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select Rinse or brush the laundry after washing.
■
The water level is too high. It is not possible to add more laundry. Close the door
■
immediately if open.
Touch A to resume the programme.
■
The door is unlocked. It is possible to add laundry.
Power consumption when left on:
0.10 W
Page 17
~
Page 17
~
Page 14
~