Finelite HP-6 Recessed Flush Diffuser Tech Zone 6" T-Bar Installation Instructions

HP-6 Recessed Flush Diffuser Tech Zone 6" T-Bar
Starter/Independent
Scan QR code for
Step 1
helpful video(s)
0 - 10V
Dimming
Diffuser
Remove diffuser and set aside to prevent it from getting dirty or dam-
aged. NOTE: If part of a longer run, diffuser will be reinstalled back
into original luminaire section as lengths vary.
Wires
Step 4
Conduit Plate
Screws
Remove conduit plate from luminaire. NOTE: Purple and gray wires
are for Low Voltage Control.
Note: All power connections to be installed to local/national codes
by a Certified Electrician.
Installation Instructions
Step 2
Starter
Configure T-Bar to luminaire size and leave an opening for luminaire as noted above.
Make sure T-Bars are aligned at 90 degrees. Place luminaire on T-Bar.
OPTIONAL SPLICE BOX
Conduit Plate
Splice Box
Bracket
Splice Box
Attach optional splice box to conduit plate by hooking onto splice box
bracket. Insert wires through feed hole.
Finelite, Inc. • 30500 Whipple Road • Union City, CA 94587-1530 • (510) 441-1100 • Fax: (510) 441-1510 • www.finelite.com
Starter
Center-to-Center
T-Bar Spacing
4"
6"
9/16" Tech Zone 6"
Step 5
Conduit Jam Nut
Conduit Plate
Run power cables through conduit plate and jam nut. Make electrical
connections. Secure conduit onto conduit plate with jam nut, and
reinstall conduit plate carefully not to damage any wiring.
Step 3
Secure to
Structure
(by others)
T-Bar Bracket
#8-18 x 1/4" Self Drilling
Screws (Provided)
Install T-Bar bracket onto luminaire. Secure with #8-18 x 1/4" screws (provided).
Secure luminaire to structure using tie-wire (by others), as per code.
OPTIONAL SPLICE BOX
Wires
Jam Nut
Conduit Plate
Run power cable through knock-out. Make electrical connection.
Secure conduit on to splice box with jam nut and close conduit plate.
1