Removing The Rotor Shipping Brace From Machines In Vertical Type; Removing Anti-Corrosion Protection - Siemens SIMOTICS FD 1LH1 Operating Instructions & Installation Instructions

5.2.4

Removing the rotor shipping brace from machines in vertical type

NOTICE
Damage to the bearing
Dismantling the rotor shipping brace when the machine is in a horizontal position could
damage the bearings.
Only remove the rotor shipping brace when the machine is in a vertical position.
NOTICE
Damage to the bearing
Failure to fit the rotor shipping brace can result in damage to the bearings while the machine
is being turned onto its side.
Fix the rotor in place before you turn the machine into a horizontal position.
Note
Store the rotor locking device
Be sure to store the rotor locking device. It must be remounted for possible disassembly and
transport.
5.2.5

Removing anti-corrosion protection

Machined, bright surfaces of machine parts and small components such as screws, bolts,
wedges, feather keys and dowel pins, are treated with an anti-corrosion agent.
Carefully remove the anti-corrosion agent just before starting the installation work.
SIMOTICS FD 1LH1
Operating Instructions 04/2016
5.2 Lift the machine to where it will be installed, and position it
Assembly
55