Panduit PANVIEW iQ PVQ-MIQPS96F Installation Instructions

© Panduit Corp. 2008
(4) P V
AN
(16) U ID (16) Grounded Bonding
LTIMATE
Label Covers
1.
While PViQ Patch Panels work interchangeably with either
the Panel Manager (PM) or the Expansion Module (EM), it is
recommended that PViQ Patch Panels be placed in a manner
that will efficiently accommodate one (1) PM for every three
(3) EMs, with appropriate cable management installed for
proper cable routing. NOTE: PM can be arranged at either
the top or bottom of order depending on need or preference.
Module Installation
3.
With the PViQ Patch Panel secured to the rack or cabinet, proceed to
install terminated jack modules into the patch panel (as shown above).
NOTE: The PViQ Patch Panel accepts all M
Modules and LC Fiber Adapters.
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
iQ Patch Panels
IEW
(4) Mounting Brackets for
Screws P V
AN IEW
Rack Mounting and Grounding
PM Installation
EM Installation
Cable
Management
EM Installation
EM Installation
-C Copper Jack
INI OM
P V
AN IEW
Intelligent Panel System
Part Number: PVQ-MIQPS96F
Hardware Components
(1) Panel
Manager (PM)
(1) Patch Cord
iQ Modules
2.
Install screws
in 4 places
Use ONLY supplied grounding screws
Mount the PViQ Patch Panel onto the face of
the rack or rack cabinet using supplied
grounding screws (as shown).
PViQ Patch Panels MUST be properly
grounded to ensure accurate system
operation.
It is advisable to prepare cable management by routing cables into a
left/right and upper/lower separation as you install the terminated jack
modules (as shown above) to reserve appropriate space for the
addition of mounting bracket later.
Page 1 of 3
iQ (PViQ) Modular
PN467
(1) PM Interface (3) Expansion
Unit Modules (EM)
(3) Expansion Port Cables
provide appropriate
grounding, the following
S
Kits from PANDUIT are
recommended:
(Recommended) Cable Routing
Leave room for
Mounting Bracket
(3) EM Interface
Units
If supplied screws
do not fit or work
with your rack or
rack cabinet to
G Rack
TRUCTURED ROUND
• Grounding Strip Kit
(Part # RGS134-1Y)
• ESD Port Kit
(Part # RGESD2-1)
• CBN Network Jumper Kit
(Part # RGCBNJ660P22)