Advertisement
Quick Links
Applies to:
Objective:
Pre-Requisites:
Description
This Technical Reference describes how to ground PVIQ Patch Panels.
Performing the Procedure
Attaching ground kits to the jack modules
1. Attach the jumper to the jacks on the back of the P
grounding wire through the grounding clip, and then attach the clip assembly onto the jumper
kit wire.
Grounding PVIQ Panels
SmartZone PVIQ Patch Panels
The purpose of this Technical Reference is to demonstrate how PV
Patch Panels can be grounded when using shielded M
(e.g. CJS6X88TGY, CJS688TGY, CJS5E88TGY).
• PANDUIT Equipment Jumper Kit (part # RGEJ1057PFY)
• (24) PANDUIT Shielded Jack Module Jumpers (part # CJSGK
includes 10 jumpers in each Kit)
Technical Reference 49-SZ
V
™ Patch Panel(s), insert the jumper
AN
IEW
Published: 7/25/18
Q™
I
™
-C
Jacks
INI
OM
1
Advertisement
Related Manuals for Panduit SmartZone PVIQ Series
Summary of Contents for Panduit SmartZone PVIQ Series
- Page 1 Patch Panels can be grounded when using shielded M Jacks (e.g. CJS6X88TGY, CJS688TGY, CJS5E88TGY). • PANDUIT Equipment Jumper Kit (part # RGEJ1057PFY) • (24) PANDUIT Shielded Jack Module Jumpers (part # CJSGK Pre-Requisites: includes 10 jumpers in each Kit) Description This Technical Reference describes how to ground PVIQ Patch Panels.
- Page 2 2. With pliers (recommend PANDUIT part # CT-100), clamp down on copper contact, and then clamp down on the cover to secure the assembly in place. 3. Repeat steps 1-2 until all termination jacks on panel(s) have a grounding wire attached.
- Page 3 • Never touch uninsulated communications wiring or terminals unless the communication line has been disconnected at the network interface. • Use caution when installing or modifying communication wiring. End State Your PVIQ Patch Panels have been grounded. www.panduit.com...