__ 3. Squeeze and pull the handle out toward you and down before you install the disk unit. If the
handle is not all the way down, the disk unit will not slide into the unit.
__ 4. Do not hold the disk unit by the handle.
__ 5. Support the bottom of the disk unit assembly as you slide it completely in and lock it in place by
closing the latch.
__ 6. Repeat the above steps for each disk unit in your system.
__ 7. Install the disk unit covers.
__ 8. Continue with the instructions.
Install tape, CD–ROM and DVD devices
__ 1. Install the device by sliding it forward and into the system unit. You may need to remove the filler
blank above the control panel.
__ 2. Connect the signal (larger connector) and power (smaller connector) cables on the back of the
device.
__ 3. Push the two latches that secure the device to the system unit frame until they stop.
View video.
Install a Model 270, 800, or 810 in a rack
27