Snom M10R KLE Quick Installation Manual page 11

Sip dect 4-line rugged handset
Hide thumbs Also See for M10R KLE:
Table of Contents

Advertisement

IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a replacement
power adapter, visit our website at
2. The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged
into a ceiling, under-the-table or cabinet outlet.
Battery installation and charging
Install the battery as shown on the following page. Once you have installed the
battery, the screen indicates the battery status (see the table below). If necessary,
place the handset in the charger to charge the battery. For best performance, keep
the handset in the charger when not in use. The battery is fully charged after 11
hours of continuous charging.
If the screen is blank, you need to charge the handset without interruption for at least
30 minutes to give the handset enough charge to use the telephone for a short time.
When the battery is low, the handset shows Low battery and a flashing .
Battery indicators
The screen is blank or
shows Place in charger
and flashes.
The screen shows Low
battery and flashes.
Full battery icon ( )
appears.
www.snomamericas.com
Battery Status
The battery has no or
little charge. The handset
cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
11
.
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
charger when not in use.

Advertisement

Table of Contents
loading

Table of Contents