Cable Lengths; Cable; Transfer Rate Changeover - Pepperl+Fuchs IDENT-I system P IPT FP Series Manual

IPT*-FP WITH U-P6-B5-V
Installation
5.4.4

Cable lengths

Depending on the type of cable used and the magnitude of the external interference, the total
expansion of an INTERBUS installation remote bus can be up to 50 m. The number of devices
connected to the bus is limited to 512.
5.4.5

Cable

The following INTERBUS installation remote bus cables should be used:
Parameter
Conductor cross-
section
The best possible EMC interference immunity can only be achieved using screened cables.
5.4.6

Transfer rate changeover

An internal slide switch enables the transfer rate to be adjusted to match that of the bus. This
allows the two values of 500 kbit/s and 2 Mbit/s to be set.
2 MBit/s
500 kBit/s
The status is preset at 2 MBit/s on delivery.
16
Standard Highly flexible
2
3 x 2 x 0.22 mm + 3 3 x 2 x 0.25 mm
2
x 1 mm x 1 mm
Schiebeschalter
Suitable for laying
underground
2
+ 3 3 x 2 x 0.22 mm
2 2
x 1 mm
2
+ 3