Table of Contents
Advertisement
Quick Links
Oct 2019 V1
OPERATION AND INSTALLATION MANUAL
Guide d'u�lisa�on et Mode d'Emploi
MULTI-FUEL & SMOKE EXEMPTION MODELS
WOODLAND DOUBLE SIDED & WOODLAND DOUBLE
SIDED LOG STORE MODEL PEDESTAL
The Woodland Double sided Catalyst
The Woodland Double sided Logstore Catalyst
- M00730-00-00-00-00
- M00733-00-00-00-00
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Mendip Stoves The Woodland Double sided Catalyst
Summary of Contents for Mendip Stoves The Woodland Double sided Catalyst
- Page 1 OPERATION AND INSTALLATION MANUAL Guide d’u�lisa�on et Mode d'Emploi MULTI-FUEL & SMOKE EXEMPTION MODELS WOODLAND DOUBLE SIDED & WOODLAND DOUBLE SIDED LOG STORE MODEL PEDESTAL The Woodland Double sided Catalyst - M00730-00-00-00-00 The Woodland Double sided Logstore Catalyst - M00733-00-00-00-00...
- Page 2 WOODLAND WOODLAND DS LS HEIGHT /Hauteur 620 mm 820 mm HEIGTH to collar / Hauteur au col 635 mm 835 mm WIDTH Top Plate/ Largeur 570 mm 570 mm WIDTH Body / Largeur 550 mm 550 mm DEPTH (Top Plate) / Profondeu 430 mm 430 mm DEPTH OF BODY ONLY ( excluding doors)
- Page 3 This manual refers to the Woodland Double sided, which is tested in accordance with EN 13240. Thank you for purchasing your new stove from Mendip Stoves. Please read this manual carefully to ensure that you get maximum enjoyment and performance from your new stove and to prevent any poten�al opera�onal problems. Please note that “all local regula�ons, including those referring to na�onal and European Standards, need to be complied with...
-
Page 4: Important Warning
IMPORTANT: These instruc�ons cover the basic principles to ensure the sa�sfactory installa�on of Mendip Stoves product :- Woodland Double sided Model , although detail may need slight modifica�on to suit par�cular local site condi�ons. -
Page 5: Adjustable Legs
I n stalling t he Woo dl a nd D ouble s ide d stove Adjustable legs The Woodland DS wood burning stove is fi�ed with adjustable legs allowing the stove to be installed on an uneven floor. To adjust the legs, prior to installa�on, wind down M8 bolts using a 13mm spanner so they protrude just below the the stove legs. - Page 6 Older proper�es, especially, may have chimney faults or the cross sec�on may be too large . Mendip Stoves recommend the use of a solid fuel flue lining system for all installa�on into exis�ng chimneys. All chimney systems must be used in accordance with Building Regula�ons Approved Document J.
- Page 7 Flue outlet posi�ons The flue outlet should be above the roof and in such a posi�on where the products of combus�on may be discharged freely what ever the wind direc�on. The discharged products of combus�on must not present a fire hazard.
- Page 8 Stove Performance & Tes�ng Ashco� Wide is tested in accordance with EN 13240. It is recommended as suitable for use in smoke control areas when burning wood logs and when fi�ed with a mechanical stop to prevent closure of the secondary air control beyond : Output Efficiency...
- Page 9 MINIMUM DISTANCE TO NON-COMBUSTIBLE MATERIALS The stove can be recessed in a suitable sized non - combus�ble fireplace but a permanent free air gap of at least 50mm must be le� around the sides, the top and the back of the stove; this is to facilitate a reasonable heat output and allows access to the stove for removal and maintenance.
- Page 10 HOW TO FIT A WOODLAND LOGSTORE Remove the internal components of the Tilt the stove onto it’s side to allow stove and fill the chamber with material easy and safe access to the feet. to prevent the bricks from falling. Unscrew the levelling bolts at the foot Addi�onally, prepare a so�...
-
Page 11: Commissioning And Handover
However as this stove needs the door to be ajar when ligh�ng and combus�on air is taken from the room when reloading. Mendip stoves recommends the use of an addi�onal air vent as laid out in document j . - Page 12 OPERATING YOUR STOVE - SUITABLE FUELS - Woodland Double sided The Universal air control provides air control for the whole stove from a single lever. The Lever has two key opera�ons Moving the control lever in and out Sliding the control lever in reduces and out increases the total amount of combus�on air in the stove. Increased Air Supply Decreased Air Supply Whatever...
- Page 13 Use the glove when opera�ng air controls and door. Reduced Air Supply in Secondary Position MENDIP STOVES RECOMMEND THE USE OF A FLUE THERMOSTAT TO CHECK YOUR STOVE IS NOT OVERHEATING. PLACE FLUE THERMOSTAT DIRECTLY ABOVE COLLAR OF STOVE AND REFER TO TEMPERATURE GAUGE ON PAGE 8.
- Page 14 USE OF HOUSE COAL AND PETROLEUM COKE ARE NOT SUITABLE FOR THIS STOVE; ITS USE WILL INVALIDATE THE GUARANTEE. BURNING WOOD IN A SMOKE CONTROL AREA You must purchase a smoke control version of the Mendip stove which is modified slightly to comply with regula�ons.
-
Page 15: Overnight Burning
Mendip Stoves are designed to burn wood. Wood burns more efficiently and cleanly when it is burnt ho�er, the typical burn cycle of a wood load is 1hr. Mendip Stoves do not recommend that their stoves are burnt overnight for this reason. As a night �me regime we recommend that the fire is loaded when hot and burnt for five minutes with the secondary air control fully open un�l the new wood has taken... -
Page 16: Troubleshooting
TROUBLE SHOOTING Fire Will Not Burn - check the air inlet is not obstructed in any way, that chimney and flue ways are clear, that a suitable fuel is being used, that there is an adequate air supply into the room, that an extractor fan is not fi�ed in the same room as the fire. -
Page 17: Maintenance
MAINTENANCE Mendip Stoves recommends that your model needs to have the ash removed from the stove at regular intervals (weekly if used daily). Allowing the ash pan to over flow can impede the func�on of the stove and can cause possible damage to the stove grate and ash pan. To remove ash pan use heat protec�ng glove provided . - Page 18 STOVE PARTS, COMBUSTION CHAMBER, ASSEMBLY PIÈCES DÉTACHÉES, VUE ÉCLATÉES This sec�on shows the parts contained in your stove, each stove has over 80 spare-parts and, each part is detailed. When new parts are required the sec�on will allow spares to be recognised and ordered. As a further source of reference please visit www.eurostove.co.uk for latest spare-part informa�on.
- Page 19 HOW TO REMOVE A VERMICULITE BRICK SET MONTAGE ET DÉMONTAGE DE L’INTÉRIEUR To remove a vermiculite brick set take the following steps Pour enlever un ensemble de briques vermiculites suivez les étapes Remove ashpan, grates and log retainers Enlever le bac cendre et l’arrêt de bûches Remove baffle bricks by removing 8 steel pins from the side walls.
- Page 20 WOODLAND DOOR ASSEMBLY ECLATE DE PORTE To find out more details, as well as to get prices and availability of these parts, please visit: www.eurostove.co.uk/the-woodland-furnace-door Woodland Double sided Handle assembly...
- Page 21 Woodland Double sided Vermiculite Brick set Poz. Číslo výkresu Název Materiál Polotovar Konfi vermeculit 800 Materiál <není EST_45051_2018_010_03_1 deflektor typ 13 určen> GRENAISOL Materiál <není EST_45051_2018_010_01_2 vermeculit 800 určen> Poz. Číslo výkresu Název EST_45051_2018_010_03_1 deflektor EST_45051_2018_010_01_2 Schváleno do vý pokud není na výkrese uvedeno jinak, dokument se řídí normami : ISO 2768-1-2 (m), EN 22553, ISO 7200, ISO všechny ostré...
- Page 24 Mendip Stoves Ltd. Unit H1 Mendip Industrial Estate Mendip Road Rooksbridge Somerset BS26 2UG Website www.mendipstoves.co.uk Email info@eurostove.co.uk Telephone 01934 750 500 Part of the Eurostove Group Woodland Double sided Manual - Version 1 - oct 2019 v1...
Need help?
Do you have a question about the The Woodland Double sided Catalyst and is the answer not in the manual?
Questions and answers