flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Proper use
Use the devices exclusively for
Cleaning using low pressure jet and de-
–
tergent (for e.g. for cleaning machines,
cars, buildings, tools),
For cleaning using high pressure jet
–
without detergent (for e.g. for cleaning
facades, terraces, garden appliances).
For stubborn dirt, we recommend the use of
the dirt blaster as a special accessory.
Safety instructions
Please follow the national rules and
–
regulations for fuel spray jets of the re-
spective country.
Please follow the national rules and
–
regulations for accident prevention of
the respective country. Fuel spray jets
must be tested regularly and the results
of these tests must be documented in
writing.
Symbols in the operating instruc-
Danger
Immediate danger that can cause severe
injury or even death.
Warning
Possible hazardous situation that could
lead to severe injury or even death.
Caution
Possible hazardous situation that could
lead to mild injury to persons or damage to
property.
4
tions
Safety Devices
Pressure switch
If the lever on the trigger gun is released
the pressure switch turns off the pump, the
high-pressure jet is stopped. If the lever is
pulled the pump is turned on again.
Overflow valve
The overflow valve prevents the permissi-
ble working pressure from being exceeded.
The overflow valve and pressure switch are
set and sealed at the factory. Setting only
by customer service.
Before Startup
Check the contents of the pack before
–
unpacking.
In case of transport damage inform ven-
–
dor immediately
Draw the push-handle upwards until the
stop.
Fasten the push handle by means of
the fastening screws.
Attaching the Accessories
Connect ray tube to hand spray gun
Install nozzle with nozzle screw at the
spray pipe.
Fasten the high pressure hose to the
high pressure connection.
Electrical connection
Warning
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
– 2
EN
Unpacking
Start up