General Inspection - Siemens SIMOTICS TN Series Operating & Installation Instructions Manual

Maintenance
9.1 Inspection and maintenance
Additional tests may also be required according to the system-specific conditions.
NOTICE
Machine damage
When carrying out the inspection, if you detect any impermissible deviations from the normal
state, you must rectify them immediately. They may otherwise cause damage to the machine.
9.1.5

General inspection

Check that the installation conditions are observed. After approximately 16,000 operating
hours – or the latest after two years – we recommend that the following checks are performed:
Table 9-2
Checking
The electrical parameters are maintained
The permissible bearing temperatures are not exceeded
The smooth running characteristics and machine running noise have not
deteriorated
The foundation has no cracks or indentations. (*)
The machine is aligned within the permissible tolerance ranges.
All the fixing bolts/screws for the mechanical and electrical connections have
been securely tightened
All the potential connections, grounding connections and shield supports are
correctly seated and properly bonded
The winding insulation resistances are sufficiently high (Page 86)
Any bearing insulation is fitted as shown on the plates and labels
The CABLES and insulating parts and components are in good condition
and there is no evidence of discoloring
Condensation can freely flow away.
(*) This check can be made at standstill or when running.
If you detect any deviations during the inspection, you must rectify them immediately. They
may otherwise cause damage to the machine.
See also
Setpoint values for monitoring the bearing temperature (Page 85)
102
Checks that have to be performed during the general inspection
When the At stand‐
motor is still
running
X
X
X
X
SIMOTICS TN Series N-compact 1LL8
Operating Instructions 11/2018
X
X
X
X
X
X
X
X