Kenwood NX-720 Service Manual page 10

NX-720
1. [ ]+Power ON.
2. "CLONE LOCK" is displayed on the LCD.
3. If the [ ] and [ ] keys is pressed while "CLONE LOCK" is
displayed, numbers (0 to 9) are displayed fl ashing. When
you press the [ ] key, the currently selected number is
determined. If you press the [ ] key after entering the
password in this procedure, "CLONE MODE" is displayed
if the entered password is correct. If the password is in-
correct, "CLONE LOCK" is redisplayed.
7-2. Flow chart (Source transceiver)
Press [
Is
password*
set?
* Read
No
Authorization
password
Start the clone function
8. Firmware Version Information
Press and hold the [ ] key while turning the transceiver
power ON and then keep pressing and holding the [ ] key,
the fi rmware version information appears on the LCD.
10
REALIGNMENT / 模式组合
] key + Power ON for 1 second
Yes
Shows CLONE LOCK
Enter password
Is entered
password
correct?
Yes
Clone mode
[ ]
1. [ ]+ 接通电源。
2. LCD 上显示"CLONE LOCK" 。
3. 如果在显示"CLO NE L OC K"时按 [
(0 到 9) 闪烁显示。按 [
在此步骤中输入密码后按 [ ] 键，如果输入的密码正确，
则显示 "CLONE MODE" 。如果密码不正确， 则重新显示 "CLONE
LOCK" 。
7-2. 流程图 ( 主车载对讲机 )
是否设置
了密码 *?
* 读取授权密码
No
8. 固件版本信息
打开车载对讲机电源时按住 [ ] 键， 然后一直按住 [ ] 键，
LCD 上便出现固件版本信息。
] 和 [
] 键即可确定当前选择的数字。
[ ] + 打开电源 (1 秒 )
是
否
显示 CLONE LOCK
输入密码
输入的密码
是否正确 ?
是
复制模式
[ ]
启动复制功能
] 键，数字
否