Kenwood NX-720 Service Manual page 18

NX-720
2. When mounting the panel assembly, pass the fl at cable
through the hole of the chassis as shown below then con-
nect the fl at cable to connector of the panel assembly.
3. Fit the panel assembly into the two tabs of the chassis
top side fi rst.
Then, fit the panel assembly into the two tabs of the
chassis bottom side by turning the panel assembly.
3. Correspondence when replacing the
LED (D22 and D23)
When replacing the LED (D22 and D23), it makes it to
length.
18
DISASSEMBLY FOR REPAIR / 维修拆卸
Chassis
底座
13mm
2. 安装面板组件时，如下图所示将带状电缆穿过底座的孔，
然后将带状电缆连接到面板组件的连接器。
Panel assembly
面板组件
Hole of Panel
assembly
the chassis
底座的孔 面板组件
/ 底座
Chassis
3. 先将面板组件装配到底座顶侧的两个凸起内。然后，再通
过转动面板组件，将面板组件装配到底座底侧的两个凸起
内。
3. 更换 LED (D22 和 D23) 时的相应操作
更换 LED (D22 和 D23) 时，将 LED 的引线截到如下图所的
尺寸。
LED LED
D22 D23
12mm