End Of Operation - V-ZUG Combair XSL Operating Instructions Manual

Checking and changing
▸ Press the touch button.
– The countdown to the time remaining appears in the display.
▸ Shorten or extend the time by turning the adjusting knob.
▸ Confirm this shortening or extending of the time.
When the timer finishes
When the set duration is up:
– An acoustic signal is emitted.
– «Timer finished» appears in the display.
▸ To close the message, select
Switching the timer off before time
▸ Press the touch button.
– The countdown to the time remaining appears in the display.
▸ Set the timer to 0 by turning the adjusting knob and confirm.
Or, if the timer is the only active function:
▸ Press the touch button.
Or, to switch off the appliance:
▸ Press the touch button 2×.
5.9

End of operation

When the set duration is up or, if the food probe is being used, when the set target tem-
perature is reached:
– The selected operating mode ends automatically.
– An acoustic signal is emitted.
– Three options are displayed:
▪ Select to choose a new operating mode
▪ Select to extend the operation
▪ Select to switch the appliance off.
– The appliance switches off automatically after 3 minutes without interaction.
You can adjust the appliance end time individually (see page 34).
– As long as the temperature is above 80 °C, «
play.
– If the food probe is plugged in, the food probe temperature is displayed. *
The food can be kept warm with residual heat for some time. As soon as the tem-
perature falls below 80 °C, all the displays go out. If at this point the food probe is
still plugged in, the displays only go out when the food probe is unplugged. *
The cooling fan can continue to run.
* Depending on the software version
.
5 Using the appliance
Residual heat» appears in the dis-
21