SYMA GYRO REMOTE CONTROL SERIES User Manual page 8

Front
Left
Back
2. Calibration for the definition of the front:
3. Toggling between headless function and normal function:
2. Press the power button on the top of the drone
to 1-2s make sure the drone is turned"ON", and
adjust the specified direction of the drone's head
under the headless mode as the new forward
Right
direc.
3. Push the left joystick (throttle) on the remote
control up to the farthest position and then pull
down to the farthest position. When the remote
control issues a long beep sound, it means the
frequency and defining forward direction
functions are completed.
1. When the drone encounters a direct impact
with foreign objects in the headless mode,
if there is an occurrence of deviation of the
defined direction, it is only required to push
both the left and right joysticks to the bottom
left corners simultaneously after placing the
flying direction of the drone in the correction
position. When the led light indicator of the
drone is in a long "ON" mode after slowly
flashing for 3 seconds, it indicates the
calibration is complete.
1. After the drone is matched with the
corresponding frequency, the drone would be
in normal pattern by default. At this time the
indicator light on the drone would be in a state
of on for a long time. After pressing in on the
right joystick of the remote control for 2
seconds, the remote control would make a
sound of "beep, beep, beep" to show that it
has entered into a state of headless mode.
Pressing in on right joystick for 2 seconds
then a long sound of "beep" would be heard to
show an exit status.(When under the state of
headless mode, four indicator lights on the
drone are led lights which flicker once every
four seconds)
-7-