SYMA GYRO REMOTE CONTROL SERIES User Manual page 14

Left/right side flight trim control
Left/right side turning trim control
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
●Consult the dealer or an experienced radio/TV technician for help.
While the drone is hovering in the air and
automatically flies left/right, press in on the left
joystick and at the same time push the right
joystick left/right slightly to fine tune the direction.
Don't release the left joystick until the drone is
flying in a stable state.
While the drone is hovering in the air, when the
drone automatically rotates and flies towards the
left/right, press in on the left joystick and at the
same time move joystick to the right or left to
adjust the direction. Don't release the left
joystick until the drone is flying in a stable state.
-13-