Advertisement
User Manual of DMR‐5R Digital Two‐way Radio
30
MSG
31
Contact
32
CC
33
ENC-KEY
34
BS-SLOT
35
CP Ver.
Note: MSG，CP Ver. doesn't support modification; ANI-ID needs to be modified via frequency writing software.
Auxiliary functions
Restore factory settings
In case of a failure of this two-way radio due to misoperation or setting error, resetting the microprocessor may solve the
problem. This function operation can be used to restore all settings and channels of this two-way radio to factory state. Memory data
and stored information may be lost during the resetting process. Before resetting, please back up or write down important data.
■All reset
Execute the operation steps below:
1) Access to the menu by pressing [MENU] key.
2) Press [ ] key or [ ] key (or enter 28 directly) until the screen shows and the pointer points to RESET; then perform the
selection operation by pressing [MENU] key.
3) Press [ ] key or [ ] key until the pointer on the screen points to ALL; then execute all reset operation by pressing [MENU] key.
4) During operation, go back and exit from the menu mode by pressing [EXIT] key. By resetting, data shall be deleted and factory
settings of the two-way radio shall be restored, therefore, this function shall be used prudently.
■VFO reset
"VFO reset" means resetting two-way radio parameters except DTMF memory, memory channel content and call channel
content. Execute the operation steps below:
1) Access to the menu by pressing [MENU] key.
2) Press [ ] key or [ ] key (or enter 28 directly) until the screen shows and the pointer points to RESET; then perform the selection
operation by pressing [MENU] key.
3) Press [ ] key or [ ] key until the pointer on the screen points to VFO; then execute VFO reset by pressing [MENU] key.
4) The screen shows WAIT... until the two-way radio is reset.
▲During operation, go back and exit from the menu mode by pressing [EXIT] key. By resetting, data shall be deleted and factory
settings of the two-way radio shall be restored, therefore, this function shall be used prudently.
■Troubleshooting guide
Without power supply, the two-way radio
doesn't work.
DMR
INBOX
Message
OUTBOX
Digital contacts
Contact name
Color code
0,1,...,15
Encryption key
Key name
SLOT1
Time slot
SLOT2
Software version
XXXXXX
Problem
The battery may has run out. Please replace or charge the battery.
The battery may be installed improperly. Please remove and reinstall the
VFO mode
Inquire the operation mode in channel
mode and modify the operation mode in
VFO mode
Inbox (not available temporarily)
Outbox (not available temporarily)
Set via frequency writing software
Set color code value in digital mode
Set via frequency writing software
Time slot 1
Time slot 2
Inquire software version number (date)
Solution
Advertisement
