Advertisement
User Manual of DMR‐5R Digital Two‐way Radio
channel parameters and can be deleted.
·Only 001 is displayed (CH character isn't displayed) , representing that Channel 001 doesn't have channel parameters, needn't
be deleted, and can be stored directly.
4） Then delete the channel by pressing [MENU] key and the channel becomes idle channel (Only channel number is displayed, CH
character isn't displayed) .
■Operation steps for storage of digital channel:
1) Select digital channel (pay attention to Symbol D) , switch to frequency mode by pressing [VFO/MR] key,
displayed on the screen.
2) In frequency mode, make A/B frequency pointer points to A (uplink frequency point)
3) Make the two-way radio operate in UHF band by pressing [BAND] key;
4) Adjust the frequency to 454.325MHZ by pressing numeric keys 4,5,4,3,2,5 in turn,
5) Power setting: Select transmitting power TXP as HIGH by pressing [MENU] →2→ [MENU]→ [ ] or [ ], then return to the
menu → [MENU];
6) Channel contacts setting: Select channel contacts CONTCT as G by pressing →31→【MENU】→[ ] or [ ],then return to the
menu → [MENU],
7) Color code setting: Select color code CC as 1 by pressing 32→【MENU】→[ ] or [ ],then return to the menu → [MENU];
8) Encryption setting: Select encryption ENC-KEY as OFF by pressing 33→【MENU】→[ ] or [ ],then return to the menu →
[MENU];
9) Time slot setting: Select time slot BS-SLOT as SLOT1 by pressing 34→【MENU】→[ ] or [ ],then return to the menu →
[MENU];
10) Frequency difference direction setting: Select frequency difference direction SFT-D as ＋ by pressing 17→【MENU】→[ ] or
[ ],then return to the menu → [MENU];
Note: The frequency difference direction in this example is ＋.
·＋ means that transmitting frequency is the receiving frequency plus frequency difference;
·－ means that transmitting frequency is the receiving frequency plus frequency difference;
·OFF means off. In frequency mode, there isn't difference between transmitting frequency and receiving frequency.
11) Frequency difference setting: Press 18→ [MENU] →voice prompt "frequency difference" and screen display OFFSET →press
numeric keys to enter 006000→[MENU].
Note: The frequency different in this example is 006.000MHZ. It shall be set according to the actual situation of the relay
station.
12) Channel storage
12.1) Access to the menu by pressing [MENU] key
12.2) Press [ ] key or [ ] key (or enter 19 directly) until the screen shows and the pointer points to MEMCH; then perform the
selection operation by pressing [MENU] key. Voice prompt "store channel" is issued.
by pressing [A/B] key.
is displayed on the screen.
is
Advertisement
