Inserting A Fortigate-5001Sx Module Into A Chassis - Fortinet FortiGate FortiGate-5001SX Security System Manual

Inserting a FortiGate-5001SX module into a chassis

Inserting a FortiGate-5001SX module into a chassis
14
The following procedure describes how to correctly use the FortiGate-5001SX
mounting components shown in
into a FortiGate-5000 series chassis slot.
The FortiGate-5001SX module left extraction lever contacts to a hidden power
switch. The module must be fully installed in a chassis slot and this extraction
lever must be closed and locked for the FortiGate-5001SX module to receive
power and operate normally. If the FortiGate-5001SX module is not receiving
power, the IPM LED glows blue and all other LEDs remain off.
It is important to carefully seat the FortiGate-5001SX module all the way into the
chassis, to not use too much force on the extraction levers, and to make sure that
the extraction levers are properly locked and engaged with the hidden power
switch. Only then will the FortiGate-5001SX module power-on and start up
correctly.
Figure 4: FortiGate-5001SX module mounting components
Alignment Pin
Mounting
Knot
Locking
Left Extraction
Screw
Lever
Figure 4 to insert a FortiGate-5001SX module
Closed
Alignment Pin
Mounting Knot
Locking
Screw
Open
Alignment Pin
Locking
Screw
Mounting Knot
Left Extraction
Lever
FortiGate-5001SX Security System Guide
Hardware installation
Left Extraction
Lever
Power
Switch
Switch
Contact
01-30000-0380-20070201